Aerial AD 110 Bedienerhandbuch Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 13
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
page 3 of 13
1. General advice
You have bought an air dryer made by AERIAL thus deciding for a proven quality
product "Made in Germany". If nevertheless complications should occur, you will
find some advice hereinafter how to eliminate such difficulties as quickly as possible.
ATTENTION PLEASE!
Immediately after receipt, you should check your air dryer for transport damage! In
the case of damage, you should inform the forwarding agent, parcel service, post
office etc. accordingly upon receipt, and make a note of it on the forwarding
documents!
If a transport damage should be stated after unpacking the equipment, please
contact immediately your respective seller or specialized trader
Before putting your air dryer into operation for the very first time, these instructions
for operation should be studied very thoroughly. Thus, you can make sure that this
appliance will operate perfectly for a long period of time saving yourselves
unnecessary repairs and expenses.
In the case of technical unclarity or faults disconnect your appliance and ensure that
it is not connected again by taking the mains plug out of the socket.
Please, keep the device wrapping in order to be able to send the device safe
for guarantee repair. In order to save place you open simply the adhesive tape
with a knife and you fold the carton.
2.Mode of operation
The AD-air dryer is constructed exclusively for air drying in closed rooms. That
dehumidifier can prevent the formation of sweating water, eliminate too high air
humidity and hold a specific air humidity unchangeable. The time which the dryer
requires in order to achieve a specific humidity depends essentially on the
environmental conditions. The attainable humidity value is equally dependent on the
environmental conditions.
The AD-dehumidifier works according to the condensation principle with heat
recovery. The fan (partial positions see detail drawing) suck the moist air through a
cool register (evaporator). The air becomes so far chilled under the point of
condensation here, that the steam of air condense as water and flows through the
connected hose into a sump. The chilled and dried air is warmed up at the
condenser again. Through the heat pump effect, the outlet air is some degrees
warmer than the sucked room air. Vigour profit can conducted up to 3-fold of the
electrical power consumption. The absolute moisture of air is lowered continuously
by the continuous circulation of the room air through the device. The surplus
moisture is removed takingly and efficiently.
Seitenansicht 2
1 2 3 4 5 6 7 8 ... 12 13

Kommentare zu diesen Handbüchern

Keine Kommentare